Product Specs

PRODUCT SPECS*

Please select product spec for EMS - Energy Management Starter

Energy Management Starter

Don't worry, you can change these later on.

This item is not in stock, you cannot put the bundle in the cart with this item.

*Disconnect

Select Disconnect Yes No

A disconnect provides short circuit protection, and a means of disconnecting power to safely service the application. Disconnects can be locked/tagged out in the open (off) position to ensure the system isn’t energized during service.

*Enclosure

Select Enclosure

Use a NEMA 1 enclosure when panels are installed in clean, indoor environment. NEMA 3R is a rainproof enclosure meant for outdoor installations.

*HP

Select HP

Check the motor nameplate to find your motor's rated Horsepower

*Phase

Select Phase

Enter single or three phase based on the incoming power distribution system.

*Voltage

Select Voltage

Check the voltage on your motor nameplate. This should be consistent with the supply voltage from your power distribution system.

*Amp

Select Amp

Check the motor nameplate to find the FLA of the motor. (SFA for submersible motors)

OPTIONS

• Ground Fault Protection w/ Trip
  No Yes
• 120V Damper Actuator Output
  No Yes
• 1-Phase Wiring for EMS starter
  No Yes
• Power Monitoring Option Board, Pulse and 4-20mA Output
  No Yes
• Data and Fault Logging Board with Date/Time Stamp, Ethernet Output
  No Yes
• Power Monitoring Option Board, Pulse and 4-20mA Output for NEMA 3R Enclosures
  No Yes
• Data and Fault Logging with Date/Time Stamp, Ethernet Output for NEMA 3R Enclosures
  No Yes
• Communications Card
  No Yes
  EMS Starter BACnet Communications Board EMS Starter Modbus Communications Board EMS Starter BACnet Communications Board for NEMA 3R Enclosures EMS Starter Modbus Communications Board for NEMA 3R Enclosures

* Required Fields